Book a WhatsApp demo
FREE TOOL FOR CUTTING ROOMS

Marker Efficiency Calculator

Marker efficiency is the share of the marker's area that ends up as garment pieces. Enter the total pattern area and the marker length and width to get the efficiency and the wasted area.

Marker efficiency formula
Marker efficiency (%) = Total pattern area ÷ (Marker length × Marker width) × 100
Wasted area = (Marker length × Marker width) − Total pattern area. Use the same units for every area.

Calculate Marker Efficiency

Pick a unit for each field. The calculator converts everything to square metres before dividing, so you can mix a length in metres with a width in inches.

Sum of all piece areas in the marker (from your CAD report or by measuring each piece)
Usable fabric width the marker is made for
Marker efficiency
Marker area (length × width)
Pattern area
Wasted area
Wasted share of the marker
Next step: turn the marker into fabric per garment with the fabric consumption calculator. For the wider picture of where cutting-room fabric goes, read the cutting room fabric waste guide.

Marker Efficiency Calculation Example

A marker is made for fabric with a usable width of 150 cm. The finished marker is 5.40 m long. The CAD report gives a total pattern area of 6.32 m² for all the pieces in the marker. These are example numbers, not a target.

Marker width150 cm = 1.50 m
Marker area5.40 m × 1.50 m = 8.10 m²
Total pattern area6.32 m²
Marker efficiency6.32 ÷ 8.10 × 100 = 78.02%
Wasted area8.10 − 6.32 = 1.78 m² (21.98% of the marker)

Every ply cut from this marker throws away 1.78 m² of fabric. If the same pieces can be nested into a shorter marker at the same width, the pattern area stays at 6.32 m², the marker area falls, and the efficiency rises.

Units matter: convert the length and width into the same unit as the pattern area before you divide. The calculator above does this for you.

What is a good marker efficiency?

There is no one good number. Marker efficiency depends on the style, the number of sizes in the marker, the fabric width, and rules such as one-way nap, stripe or check matching. Compare a marker against earlier markers for the same style and fabric, not against a figure from a different product. A higher percentage means less fabric is wasted.

How do you increase marker efficiency?

Put more sizes in one marker so large and small pieces nest together. Set the marker width to the narrowest usable fabric width in the lot. Allow pieces to be flipped or rotated where the fabric permits. Place small pieces in the gaps between large ones. Re-check the marker after any pattern change instead of reusing an old one.

Marker Efficiency in the Garment Industry

In a cutting room, the marker decides how much fabric each lay uses before a single ply is spread. Fabric is usually the largest material cost in a garment, so a marker that wastes less area lowers the cost of every piece cut from it. That is why marker efficiency is checked before the marker goes to the cutting table.

How to calculate marker efficiency by hand

Marker efficiency only measures waste inside the marker. Fabric is also lost at the ends of each lay, at splices, and through cutting errors, so add those separately when you plan fabric for an order. The garment costing and CMT calculation guide shows where fabric cost sits in the full garment cost.

Track Every Lay, Not Just the Marker.

Scan ERP records cutting batches, lots and bundles with QR codes, so you can see what was cut from each lay without a paper cutting register.

Book a Free Demo